Data Sheet for Product

Technical Specification Sheet
Document No. 149-1021
December 02, 2014
Siemens Industry, Inc. Page 1 of 2
EcoView™ 8 DO Module
Description
The EcoView 8 DO Module is a rugged, eight channel, pilot
duty relay controller that is part of the EcoView system.
Each channel can switch 3 amps at up to 24 Vac or
30 Vdc for pilot duty service (pass through). Control is
accomplished by a ZigBee 802.15.4 link back to the
EcoView Touchscreen.
Functionality
• On Timer: On times are passed to the device.
Even with loss of communication to the
Touchscreen, the channel will turn off after the set
Run (On) time.
• Delay Time: Provides a minimum delay time
between relays allowing for load shedding with
one schedule point.
Technical Specifications
Input Power
• 12 Vdc at 1 amp supply.
• Reverse voltage protected.
• Consumption: 30 mA to 240 mA depending on
number of channels activated.
Communications
• ZigBee 802.15.4 link to Touchscreen.
• Range: up to 300’ with high power XBee.
• Mesh networking with other EcoView products
allowing for greater range.
• Range boosting available via ZigBee Repeater.
Microcontroller/Interface
• Real time clock for program retention if ZigBee
network is lost.
• Watchdog circuit for reliable operation.