Installation Instructions
Table Of Contents
Installation Instructions
Document No. 129-184
September 25, 2009
Flowrite™ AP 599 Series 12-inch
Pneumatic Valve Actuator
Item Number129-184, Rev. 400 Page 1 of 4
Product Description
The Flowrite AP 599 Series 12-inch Pneumatic
Valve Actuator is designed for use with the Flowrite
VF 599 Series Valves with a 3/4-inch (20 mm) or
1-1/2 inch (40 mm) stroke.
Product Numbers
599-01000
599-01010
Warning/Caution Notations
WARNING
Personal injury/loss of life may
occur if a procedure is not
performed as specified.
CAUTION
Equipment damage, or loss of
data may occur if the user
does not follow procedure as
specified.
Required Tools
• 24 and 30 mm open-end wrenches
• 3/8, 9/16, and 1-1/16 inch open-end
wrenches
Expected Installation Time
60 minutes for field mounting of the actuator
100 minutes for removing and replacing an actuator
Prerequisites
WARNING:
If mounting the actuator to a valve already
in line, either close the shut-off valves in
the piping (upstream first, then
downstream) or switch off the pump to
allow the differential and static pressure in
the valve to drop.
CAUTION:
Do not damage or scratch the polished
surface of the valve stem.
Figure 1. Acceptable Mounting Positions.
The vertical position is recommended for mounting.
Figure 1 shows the acceptable mounting positions.