Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCsPLC add-on module 6AG1131-4BD01-7AB0

Data sheet 6AG1131-4BD01-7AB0

SIPLUS ET 200S EM 4DI HF -25...+70°C based on 6ES7131-

4BD01-0AB0 5 units per packing unit

Supply voltage

Rated value (DC)

● 24 V DC

Yes; From power module

Reverse polarity protection Yes

Input current

from supply voltage L+, max. Dependent on encoder

from backplane bus 3.3 V DC, max. 10mA

Encoder supply

Type of output voltage min. L+ (-0.5 V), under load

Short-circuit protection Yes; Electronic

Output current

● Rated value

500mA

● permissible range, lower limit

0mA

● permissible range, upper limit

500mA

Power loss

Power loss, typ. 0.7W

Address area

6AG1131-4BD01-7AB0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6AG1131-4BD01-7AB0 SIPLUS ET 200S EM 4DI HF -25...+70°C based on 6ES71314BD01-0AB0 5 units per packing unit Supply voltage Rated value (DC) ● 24 V DC Reverse polarity protection Yes; From power module Yes Input current from supply voltage L+, max. Dependent on encoder from backplane bus 3.3 V DC, max. 10 mA Encoder supply Type of output voltage min. L+ (-0.
PAGE 2
Address space per module ● Address space per module, max. 1 byte ● with packing 4 bit Digital inputs Number of digital inputs 4 Input characteristic curve in accordance with IEC 61131, type 1 Yes Input voltage ● Type of input voltage DC ● Rated value (DC) 24 V ● for signal "0" -30 to +5V ● for signal "1" +11 to +30V Input current ● for signal "1", typ. 8 mA Input delay (for rated value of input voltage) for standard inputs — parameterizable Yes; 0.1 / 0.
PAGE 3
Potential separation digital inputs ● between the channels No ● between the channels and backplane bus Yes Permissible potential difference between different circuits 75 V DC/60 V AC Isolation Isolation tested with 500 V DC Standards, approvals, certificates CE mark Yes Ambient conditions Ambient temperature during operation ● min. -25 °C; = Tmin ● max. 70 °C; = Tmax Altitude during operation relating to sea level ● Installation altitude above sea level, max.
PAGE 4
Remark — Note regarding classification of environmental conditions acc. to EN 60721, EN 60654-4 and ANSI/ISA-71.04 * The supplied plug covers must remain in place over the unused interfaces during operation! Dimensions Width 15 mm Height 81 mm Depth 52 mm Weights Weight, approx.