Data Sheet

Data sheet 6AG1134-4MB02-2AB0

SIPLUS ET 200S EM 2 AE I HF -25...+70°C with conformal coating

based on 6ES7134-4MB02-0AB0 . Electronic module 15 mm Overall

width, Cycle time per module: 0.5 ms, "+/-20 mA; 15 bit+sign, ""4.."

"20mA; 15 bit,"" Operational" limit +/-0.1% with SF LED (group fault)

Supply voltage

Load voltage L+

● Rated value (DC)

24V

● Reverse polarity protection

Yes

Input current

from load voltage L+ (without load), max. 48mA

from backplane bus 3.3 V DC, max. 10mA

Output voltage

Power supply to the transmitters

● present

Yes

● short-circuit proof

Yes

Power loss

Power loss, typ. 1.2W

Address area

Address space per module

● Address space per module, max.

4byte

Analog inputs

6AG1134-4MB02-2AB0 Subject to change without notice

Page 1/

PAGE 1
Data sheet 6AG1134-4MB02-2AB0 SIPLUS ET 200S EM 2 AE I HF -25...+70°C with conformal coating based on 6ES7134-4MB02-0AB0 . Electronic module 15 mm Overall width, Cycle time per module: 0.5 ms, "+/-20 mA; 15 bit+sign, ""4.." "20mA; 15 bit,"" Operational" limit +/-0.1% with SF LED (group fault) Supply voltage Load voltage L+ ● Rated value (DC) 24 V ● Reverse polarity protection Yes Input current from load voltage L+ (without load), max. 48 mA from backplane bus 3.3 V DC, max.
PAGE 2
Number of analog inputs 2 permissible input current for current input (destruction limit), max. 50 mA Cycle time (all channels) max. 0.5 ms; 0.5 ms for 2 channels without noise suppression, 18 / 21 ms per channel with noise suppression Input ranges (rated values), currents ● -20 mA to +20 mA Yes ● 4 mA to 20 mA Yes Cable length ● shielded, max.
PAGE 3
● Series mode interference (peak value of interference < rated value of input range), min. 90 dB ● Common mode interference (USS < 2.5 V) , min.
PAGE 4
● With condensation, tested in accordance with IEC 60068-2-38, max. 100 %; RH incl. condensation/frost permitted (no commissioning in bedewed state) Resistance Use in stationary industrial systems — to biologically active substances according to EN 60721-3-3 Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna); Class 3B3 on request — to chemically active substances according to EN 60721-3-3 Yes; Class 3C4 (RH < 75 %) incl. salt spray acc.