Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6AG1136-6PA00-2BC0 PLC add-on module

Data sheet 6AG1136-6PA00-2BC0

SIPLUS ET 200SP -25...+60°C with conformal coating based on

6ES7136-6PA00-0BC0 . Power Module F-PM-E, PPM PROFIsafe,

24 V DC, safe shutdown of DQ and F-DQ up to PL D, SIL2 or PL E

SIL3 2 for safe, dig. inputs, 1 for safe dig. output PPM

General information

Product type designation F-PM-E 24 V DC/8 A PPM ST

Firmware version

● FW update possible

Yes

usable BaseUnits BU type C0

Color code for module-specific color identification

plate

CC52

Product function

● I&M data

Yes; I&M0 to I&M3

Supply voltage

Rated value (DC) 24V

permissible range, lower limit (DC) 20.4V

permissible range, upper limit (DC) 28.8V

Reverse polarity protection Yes

Input current

Current consumption (rated value) 75mA; without load

Current consumption, max. 21mA; From the backplane bus

Output voltage

6AG1136-6PA00-2BC0 Subject to change without notice

Page 1/

Summary of content (5 pages)

PAGE 1
Data sheet 6AG1136-6PA00-2BC0 SIPLUS ET 200SP -25...+60°C with conformal coating based on 6ES7136-6PA00-0BC0 . Power Module F-PM-E, PPM PROFIsafe, 24 V DC, safe shutdown of DQ and F-DQ up to PL D, SIL2 or PL E SIL3 2 for safe, dig. inputs, 1 for safe dig.
PAGE 2
Rated value (DC) 24 V Encoder supply Number of outputs 2 Short-circuit protection Yes; Electronic (response threshold 0.7 A to 2.1 A) Output current ● up to 60 °C, max. 0.3 A 24 V encoder supply ● 24 V Yes; min. L+ (-1.5 V) ● Short-circuit protection Yes ● Output current, max. 600 mA; Total current of all encoders Power Power available from the backplane bus 70 mW Power loss Power loss, typ.
PAGE 3
● shielded, max. 1 000 m ● unshielded, max. 500 m Digital outputs Number of digital outputs 1 Short-circuit protection Yes Open-circuit detection Yes ● Response threshold, typ. Overload protection ● Response threshold, typ. Limitation of inductive shutdown voltage to 8 mA Yes 8.8 A max. 1.5 V Switching capacity of the outputs ● with resistive load, max. 8A ● on lamp load, max. 100 W Load resistance range ● lower limit 3Ω ● upper limit 2 000 Ω Output voltage ● for signal "1", min.
PAGE 4
● Channel status display Yes; Green LED ● for channel diagnostics Yes; Red LED ● for module diagnostics Yes; green/red DIAG LED Potential separation Potential separation channels ● between the channels No ● between the channels and backplane bus Yes ● between the channels and the power supply of the electronics No Isolation Isolation tested with 707 V DC (type test) Standards, approvals, certificates Highest safety class achievable in safety mode ● Performance level according to ISO 13849-1 P
PAGE 5
Use on ships/at sea — to biologically active substances according to EN 60721-3-6 Yes; Class 6B2 mold, fungal and dry rot spores (excluding fauna) — to chemically active substances according to EN 60721-3-6 Yes; Class 6C3 (RH < 75 %) incl. salt spray acc. to EN 60068-252 (severity degree 3); * — to mechanically active substances according to EN 60721-3-6 Yes; Class 6S3 incl. sand, dust; * — Against mechanical environmental conditions acc.