Data Sheet

Data sheet 6AG1151-1AA06-7AB0

SIPLUS ET 200S IM 151-1 standard -25...+70°C with conformal

coating based on 6ES7151-1AA06-0AB0 . Interface module incl.

termination module Data volume of 244 bytes each "for inputs and

outputs; max. 63" I/O modules PROFIBUS DP V0 and V1 up to 2 m

width can be "connected; Bus connection via" 9-pin D-sub

General information

Product type designation IM 151-1 ST

Vendor identification (VendorID) 806Ah

Supply voltage

Mains buffering

● Mains/voltage failure stored energy time

20ms

Input current

from supply voltage 1L+, max. 200mA

Power loss

Power loss, typ. 3.3W

Address area

Addressing volume

● Inputs

244byte

● Outputs

244byte

Interfaces

Transmission procedure RS 485

Interface physics, RS 485 Yes; 9-pin sub D socket

6AG1151-1AA06-7AB0 Subject to change without notice

Page 1/

PAGE 1
Data sheet 6AG1151-1AA06-7AB0 SIPLUS ET 200S IM 151-1 standard -25...+70°C with conformal coating based on 6ES7151-1AA06-0AB0 . Interface module incl. termination module Data volume of 244 bytes each "for inputs and outputs; max.
PAGE 2
PROFIBUS DP ● Output current, max. 80 mA ● Transmission rate, max. 12 Mbit/s; 9,6 / 19,2 / 45,45 / 93,75 / 187,5 / 500 kbit/s; 1,5 / 3 / 6 / 12 Mbit/s ● SYNC capability Yes ● FREEZE capability Yes ● Direct data exchange (slave-to-slave communication) Yes ● Cable length, max.
PAGE 3
● With condensation, tested in accordance with IEC 60068-2-38, max. 100 %; RH incl. condensation / frost (no commissioning in bedewed state), horizontal installation Resistance Use in stationary industrial systems — to biologically active substances according to EN 60721-3-3 Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna); Class 3B3 on request — to chemically active substances according to EN 60721-3-3 Yes; Class 3C4 (RH < 75 %) incl. salt spray acc.