Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6AG1336-4GE00-2AB0 PLC add-on module

Data sheet 6AG1336-4GE00-2AB0

SIPLUS S7-300 SM336 F 6AI 15 bit -25...+60 °C (70 °C with forced

convection) With conformal coating Based on 6ES7336-4GE00-0AB0

. Fail-safe analog inputs For SIMATIC Safety, with HART support, up

to Category 4 (EN 954-1) /SIL3 (IEC 61508)/ PLE (ISO 13849), 1x

20-pole

Supply voltage

Rated value (DC) 24V; ±5 %

Reverse polarity protection Yes

Input current

From power supply L+, typ. 150mA

from backplane bus 5 V DC, max. 90mA

Power loss

Power loss, typ. 4.5W

Analog inputs

Number of analog inputs 6

permissible input current for current input (destruction

limit), max.

40mA

Input ranges

● Voltage

● Current

Yes

Input ranges (rated values), currents

6AG1336-4GE00-2AB0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6AG1336-4GE00-2AB0 SIPLUS S7-300 SM336 F 6AI 15 bit -25...+60 °C (70 °C with forced convection) With conformal coating Based on 6ES7336-4GE00-0AB0 . Fail-safe analog inputs For SIMATIC Safety, with HART support, up to Category 4 (EN 954-1) /SIL3 (IEC 61508)/ PLE (ISO 13849), 1x 20-pole Supply voltage Rated value (DC) 24 V; ±5 % Reverse polarity protection Yes Input current From power supply L+, typ. 150 mA from backplane bus 5 V DC, max. 90 mA Power loss Power loss, typ. 4.
PAGE 2
● 0 to 20 mA Yes ● Input resistance (0 to 20 mA) 150 Ω; typ. 150 ohms max. 175 ohms ● 4 mA to 20 mA Yes ● Input resistance (4 mA to 20 mA) 150 Ω; typ. 150 ohms max. 175 ohms Cable length ● shielded, max. 1 000 m Analog value generation for the inputs Integration and conversion time/resolution per channel ● Integration time (ms) 20 ms @ 50 Hz, 16.7 ms @ 60 Hz ● Interference voltage suppression for interference frequency f1 in Hz f=n x (f1 ±0.
PAGE 3
Highest safety class achievable in safety mode ● acc. to EN 954 4 ● SIL acc. to IEC 61508 SIL 3 Ambient conditions Ambient temperature during operation ● min. -25 °C; = Tmin; Startup @ -25 °C ● max. 60 °C; = T max; *+70 °C when forced convection at a minimum air speed of 0.3 m/s through the modules is ensured.
PAGE 4
Remark — Note regarding classification of environmental conditions acc. to EN 60721, EN 60654-4 and ANSI/ISA-71.04 * The supplied plug covers must remain in place over the unused interfaces during operation! Connection method required front connector 20-pin Dimensions Width 40 mm Height 125 mm Depth 120 mm Weights Weight, approx.