Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCsPLC add-on module 6AG2136-6BA00-1CA0

Data sheet 6AG2136-6BA00-1CA0

SIPLUS ET 200SP F-DI 4/8X24 V DC RAIL -25 ... +55°C T1 with

70°C for 10 min with conformal coating based on 6ES7136-6BA00-

0CA0 . 15 mm overall width, up to PL E (ISO 13849-1)/ SIL3 (IEC

61508)

General information

Product type designation F-DI 8x24VDC HF

Firmware version

● FW update possible

Yes

usable BaseUnits BU type A0

Product function

● I&M data

Yes; I&M0 to I&M3

Supply voltage

Rated value (DC) 24V

permissible range, lower limit (DC) 20.4V

permissible range, upper limit (DC) 28.8V

Reverse polarity protection Yes

Input current

Current consumption (rated value) 75mA; without load

Current consumption, max. 21mA; From the backplane bus

Encoder supply

Number of outputs 8

Short-circuit protection Yes; Electronic (response threshold 0.7 A to 1.8 A)

6AG2136-6BA00-1CA0 Subject to change without notice

Page 1/

Summary of content (5 pages)

PAGE 1
Data sheet 6AG2136-6BA00-1CA0 SIPLUS ET 200SP F-DI 4/8X24 V DC RAIL -25 ... +55°C T1 with 70°C for 10 min with conformal coating based on 6ES7136-6BA000CA0 . 15 mm overall width, up to PL E (ISO 13849-1)/ SIL3 (IEC 61508) General information Product type designation F-DI 8x24VDC HF Firmware version ● FW update possible usable BaseUnits Yes BU type A0 Product function ● I&M data Yes; I&M0 to I&M3 Supply voltage Rated value (DC) 24 V permissible range, lower limit (DC) 20.
PAGE 2
Output current ● up to 60 °C, max. 0.3 A 24 V encoder supply ● 24 V Yes; min. L+ (-1.5 V) ● Short-circuit protection Yes ● Output current, max. 800 mA; Total current of all encoders Power Power available from the backplane bus 70 mW Power loss Power loss, typ.
PAGE 3
Interrupts/diagnostics/status information Diagnostics function Yes, "Alarms/diagnostic messages" section in the manual Alarms ● Diagnostic alarm Yes ● Hardware interrupt No Diagnostics indication LED ● RUN LED Yes; Green LED ● ERROR LED Yes; Red LED ● Monitoring of the supply voltage (PWR-LED) Yes; Green PWR LED ● Channel status display Yes; Green LED ● for channel diagnostics Yes; Red LED ● for module diagnostics Yes; green/red DIAG LED Potential separation Potential separation channels ●
PAGE 4
● EN 50125-3 Yes; Signal and telecommunications systems - see ambient conditions; vibrations and shocks: Application point outside of tracks (1 m to 3 m away from track) ● EN 50155 Yes; Rail vehicles - temperature class T1, horizontal mounting position, salt spray Class ST2 ● EN 61373 Yes; Rail vehicles - vibrations and shocks: Category 1 Class A/B ● Fire protection acc.
PAGE 5
— Against chemically active substances acc. to EN 60654-4 Yes; Class 3 (excluding trichlorethylene) — Environmental conditions for process, measuring and control systems acc. to ANSI/ISA-71.04 Yes; Level GX group A/B (excluding trichlorethylene; harmful gas concentrations up to the limits of EN 60721-3-3 class 3C4 permissible); level LC3 (salt spray) and level LB3 (oil) Remark — Note regarding classification of environmental conditions acc. to EN 60721, EN 60654-4 and ANSI/ISA-71.