Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCsPLC add-on module 6AG2136-6DB00-1CA0

Data sheet 6AG2136-6DB00-1CA0

SIPLUS ET 200SP F-DQ 4 x 24 V DC/2 A PM RAIL -25 ... +55°C T1

with 70°C for 10 min with conformal coating based on 6ES7136-

6DB00-0CA0 . 15 mm overall width, up to PL E (ISO13849) up to SIL

3 (IEC 61508)

General information

Product type designation F-DQ 4x24VDC HF

Firmware version

● FW update possible

Yes

usable BaseUnits BU type A0

Color code for module-specific color identification

plate

CC02

Product function

● I&M data

Yes; I&M0 to I&M3

Supply voltage

Rated value (DC) 24V

permissible range, lower limit (DC) 20.4V

permissible range, upper limit (DC) 28.8V

Reverse polarity protection Yes

Input current

Current consumption (rated value) 75mA; without load

Current consumption, max. 21mA; From the backplane bus

Output voltage

6AG2136-6DB00-1CA0 Subject to change without notice

Page 1/

Summary of content (5 pages)

PAGE 1
Data sheet 6AG2136-6DB00-1CA0 SIPLUS ET 200SP F-DQ 4 x 24 V DC/2 A PM RAIL -25 ... +55°C T1 with 70°C for 10 min with conformal coating based on 6ES71366DB00-0CA0 .
PAGE 2
Rated value (DC) 24 V Power Power available from the backplane bus 70 mW Power loss Power loss, typ. 4W Address area Address space per module ● Inputs 5 byte ● Outputs 5 byte Digital outputs Number of digital outputs 4 Digital outputs, parameterizable Yes Short-circuit protection Yes ● Response threshold, typ. Open-circuit detection ● Response threshold, typ. Overload protection ● Response threshold, typ. Limitation of inductive shutdown voltage to > 3.3 A Yes 8 mA Yes 2.9 A typ.
PAGE 3
Interrupts/diagnostics/status information Diagnostics function Yes, "Alarms/diagnostic messages" section in the manual Substitute values connectable No Alarms ● Diagnostic alarm Yes Diagnostics indication LED ● RUN LED Yes; Green LED ● ERROR LED Yes; Red LED ● Monitoring of the supply voltage (PWR-LED) Yes; Green PWR LED ● Channel status display Yes; Green LED ● for channel diagnostics Yes; Red LED ● for module diagnostics Yes; green/red DIAG LED Potential separation Potential separation c
PAGE 4
● EN 50125-3 Yes; Signal and telecommunications systems - see ambient conditions; vibrations and shocks: Application point outside of tracks (1 m to 3 m away from track) ● EN 50155 Yes; Rail vehicles - temperature class T1, horizontal mounting position, salt spray Class ST2 ● EN 61373 Yes; Rail vehicles - vibrations and shocks: Category 1 Class A/B ● Fire protection acc.
PAGE 5
— Against chemically active substances acc. to EN 60654-4 Yes; Class 3 (excluding trichlorethylene) — Environmental conditions for process, measuring and control systems acc. to ANSI/ISA-71.04 Yes; Level GX group A/B (excluding trichlorethylene; harmful gas concentrations up to the limits of EN 60721-3-3 class 3C4 permissible); level LC3 (salt spray) and level LB3 (oil) Remark — Note regarding classification of environmental conditions acc. to EN 60721, EN 60654-4 and ANSI/ISA-71.