Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6BK1942-2CA00-0AA1

Data sheet 6BK1942-2CA00-0AA1

SIPLUS HCS4200 POM4220 Midrange Phase angle. Power output

module (POM) for inserting in a HCS RACK4200. with 12 outputs

each max. 4432 W. (for operating mode zero-point switching:

depending on the Inrush current of the load limitation to max. 1600

General information

Product type designation POM4220 mid-range phase control

Installation type/mounting

Mounting type Screw mounting to rack

Mounting position vertical

Type of ventilation Self ventilation or forced ventilation

Supply voltage

Type of supply voltage AC

Rated value (AC) 230V

Relative negative tolerance 10%

Relative positive tolerance 30%

2nd rated value (AC) 277V

Relative negative tolerance 25%

Relative positive tolerance 8%

Line frequency

● Rated value 50 Hz

Yes

● Rated value 60 Hz

Yes

● Relative symmetrical tolerance

5%

6BK1942-2CA00-0AA1 Subject to change without notice

Page 1/

Summary of content (5 pages)

PAGE 1
Data sheet 6BK1942-2CA00-0AA1 SIPLUS HCS4200 POM4220 Midrange Phase angle. Power output module (POM) for inserting in a HCS RACK4200. with 12 outputs each max. 4432 W. (for operating mode zero-point switching: depending on the Inrush current of the load limitation to max.
PAGE 2
Mains buffering ● Recovery time after power failure, typ. 1s Connection method ● Design of electrical connection for supply voltage Connector, 3-pole with spring-loaded connection — Connectable conductor cross-sections, solid 1x (0.75 ... 16 mm²) — Connectable conductor cross-sections, finely stranded with wire end processing 1x (0.75 ... 16 mm²) — Connectable conductor cross-sections for AWG cables 1x (18 ...
PAGE 3
— for heating elements with high inrush current, max. 1 600 W; At 230 V AC ● Output current for heating power 16 A; max. ● Melting I2t value 20 A²·s ● Design of short-circuit protection per output Fuse 16 A ● Design of overvoltage protection Transil Diode Connection method ● Design of electrical connection at output for heating and fan Connector, 6-pole with spring-loaded connection — Connectable conductor cross-sections, solid 1x (0.2 ...
PAGE 4
● Fault current detection No Potential separation Design of electrical isolation Optocoupler and/or protective impedance between main circuit and PELV between the outputs No Isolation Overvoltage category III Degree of pollution 2 EMC EMC interference emission Limit value in accordance with IEC 61000-6-4:2007 + A1:2011 Electrostatic discharge acc. to IEC 61000-4-2 4 kV contact discharge / 8 kV air discharge Field-related interference acc. to IEC 61000-4-3 10 V/m (80 ... 1 000 MHz), 3 V/m (1.
PAGE 5
● Storage, min. 660 hPa ● Storage, max. 1 080 hPa Altitude during operation relating to sea level ● Installation altitude above sea level, max. 2 000 m Relative humidity ● Operation at 25 ℃, max. 95 % ● Operation at 50 ℃, max. 50 %; 95 % at 25 °C, decreasing linearly to 50 % at 50 °C Vibrations ● Vibration resistance during operation acc. to IEC 60068-2-6 10 ... 58 Hz / 0.075 mm, 58 ... 150 Hz / 1 g ● Vibration resistance during storage acc. to IEC 60068-2-6 5 ... 8.5 Hz / 3.5 mm, 8.5 ...