User Manual

LOGO! functions
4.4 Special functions list - SF
LOGO!
244 Manual, 04/2011, A5E03556174-01
Setting the Par parameter
View in programming mode (example):
1. Select the 'Softkey' function.
2. Select input En and confirm with OK. The cursor is now positioned below 'Par'.
3. Change to the input mode of 'Par': Confirm with OK
(the cursor is now positioned to 'On')
%
6WDUW 2Q
2Q
7KHVWDWXVLVQRWUHWHQWLYH
4LVVHWLQWKHILUVWSURJUDPF\FOH
DIWHUSURJUDPVWDUW
ಯ0RPHQWDU\SXVKEXWWRQರIXQFWLRQ
To change 'Par' to 'Switch' action and the initialization status after the program start:
4. To select 'Momentary pushbutton' or 'Switch' action: Press
or
%
6WDUW 2Q
2Q2II
ಯ6ZLWFKರ
7KHVWDWXVLVQRWUHWHQWLYH
4LVVHWLQWKHILUVWSURJUDPF\FOH
DIWHUSURJUDPVWDUW
5. To change to the start state: Press
or
6. To change the start state: Press
or
%
6WDUW 2II
2Q2II
ಯ6ZLWFKರ
7KHVWDWXVLVQRWUHWHQWLYH
4LVVHWLQWKHLQLWSURJUDPF\FOH
DIWHUSURJUDPVWDUW
7. Confirm your entries with OK
View in parameter assignment mode (example):
Here, you can set or reset the 'Switch' parameter (On/Off). When in RUN, LOGO! shows the
following display:
%
6ZLWFK 2II
7KHSXVKEXWWRQVZLWFKKHUHLV
VZLWFKHGRII