User Manual

Configuring LOGO!
7.1 Selecting parameter assignment mode
LOGO!
292 Manual, 04/2011, A5E03556174-01
7.1.3 Modifying parameters
You first select the parameter you want to edit (Page 291).
You change the value of the parameter in the same way as you did in programming mode:
1. Move the cursor to the point at which you want to make the change:
Press
or
2. To change this value: Press
or
3. To apply the value: OK
7D V
7 V
%
&KDQJH3UHVV
Ⴃ
RU
Ⴍ
'RQH2.
0RYH3UHVV
Ⴑ
RU
Ⴇ
Note
When changing the time parameter when the system is in RUN, you can also change the
timebase (s=seconds, m=minutes, h=hours). This does not apply if the time parameter
represents the result of another function (for an example, see the "On-delay (Page 160)"
topic)
. In this case you can neither change the value nor the timebase. The current time is
reset to zero when you change the timebase.
Current value of a time T
View of a time T in parameter assignment mode:
7D V
7 V
%
&XUUHQWWLPH7D
&RQILJXUHGWLPH7
You can change the configured time T.
Current timer value
View of a timer cam in parameter assignment mode:
2II 
2Q 
' 0:)
%
You can change the on/off times and the day.