User Manual

Applicable cards
8.3 Copying data from LOGO! to the card
LOGO!
Manual, 04/2011, A5E03556174-01
309
8.3 Copying data from LOGO! to the card
Copying data from LOGO! to the card manually
To manually copy the circuit program to the memory card, combined battery/memory card, or
the SD card, follow these steps:
1. Insert the card into the slot.
2. Switch LOGO! to programming mode (ESC / >Stop).
/2*2PDLQPHQX
6WDUW
6HWXS
&DUG
!3URJUDP
3. The main menu opens. To select the 'Card' command: Press
or
4. Press OK. The transfer menu opens.
/2*2
&RS\3URWHFW
&DUG
ൺ&DUG
!
5. Move the '>' cursor to 'LOGO → Card' (if required): Press
or
6. Press OK.
LOGO! now copies the circuit program to the card. (If the card is from an incompatible
0BA0..0BA4 version, LOGO! displays this message: "Card unknown/ Press ESC".)
When LOGO! has finished copying, it automatically returns you to the main menu:
6WDUW
6HWXS
&DUG
!3URJUDP
The circuit program backup is now stored on your card and you can remove the card. Do not
forget to replace the cap.
If power fails while LOGO! is copying the circuit program, repeat the process after Power On.
Note
The password of a protected circuit program in LOGO! also applies to the copied program
version on your card.