User Manual

Applicable cards
8.4 Copying data from the card to LOGO!
LOGO!
Manual, 04/2011, A5E03556174-01
311
8.4 Copying data from the card to LOGO!
You can copy a circuit program from a compatible memory card, combined memory/battery
card, or an SD card to LOGO! in one of the following ways:
● Automatically during the startup of LOGO! (POWER ON)
● By means of the "Card" menu of LOGO!
● By means of the "Card" menu of the LOGO! TD (version ES7)
Note
If the program on the module/card is protected with a password, the copied program in
LOGO! is also protected with the same password.
Automatic copying during the startup of LOGO!
Proceed as follows:
1. Switch off the power supply to LOGO! (POWER OFF)
2. Remove the slot cover.
3. Insert the card into the relevant slot.
4. Switch on the power supply to LOGO!
LOGO! copies the program from the program module/card to LOGO!. (If the card is from
an incompatible 0BA0..0BA3 version, LOGO! displays this message: "Unknown Card /
Press ESC".)
When LOGO! has finished copying, it opens the main menu:
6WDUW
6HWXS
&DUG
!3URJUDP
Note
Before you switch LOGO! to RUN, you must ensure that the system you are controlling
with LOGO! does not represent a source of hazard.
5. Move the '>' cursor to 'Start': Press or
6. Press OK.