User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
90 Manual, 04/2011, A5E03556174-01
3.7.4 Assigning a circuit program name
You can assign your circuit program a name that consists of up to 16 uppercase/lowercase
letters, numbers and special characters.
When LOGO! is in the view below, follow these steps:

0VJ&RQILJ
3DVVZRUG
&OHDU3UJ
!(GLW
1. Press
or to move the ">" cursor to "①".
2. To confirm "
①", press OK.

$4
0HPRU\"
(GLW3UJ
!(GLW1DPH
3. Press
or to move the ">" cursor to "②".
4. To confirm "
②", press OK.
Press
and to list the alphabet, numbers and special characters, either in ascending or
descending order. You can select any letter, number or character.
To enter a space character, simply move the cursor with
to the next position. This
character is the first one in the list.
Examples:
Press
once to select an " A ". Press four times to select " { ", etc.
The following character set is available:
A B C D E F G H I J K L M N O
P Q R S T U V W X Y Z a b c d e
f g h i j k l m n o p q r s t u
v w x y z 0 1 2 3 4 5 6 7 8 9 !
" # $ % & ' ( ) * + , - . / : ;
< = > ? @ [ \ ] ^ _ ' { | } ~
Assuming that you want to name your circuit program "ABC", proceed as follows:
1. Select " A
": Press
2. Move to the next letter: Press
3. Select " B
": Press
4. Move to the next letter: Press
5. Select " C
": Press
6. Confirm the complete name: Press O
K