Datasheet

ManualsBrandsSIEMENS ManualsRack & DIN Rail Mount PSUsSITOP lite PSU100L DIN Rail Power Supply 24Vdc 10A 240W, Single-Phase

Product data sheet 6EP1334-1LB00

SITOP PSU100L 24 V/10 A STABILIZED POWER SUPPLY

INPUT: 120/230 V AC OUTPUT: 24 V/10 A DC

Technical specifications

Product SITOP PSU100L

Power supply, type 24 V/10 A

Input

Input 1-phase AC

Supply voltage / 1 / at AC / nominal value 120 V

Supply voltage / 2 / at AC / nominal value 230 V

Voltage range

• Note Set by means of selector switch on the device

Input voltage / 1 / at AC 93 … 132 V

Input voltage / 2 / at AC 187 … 264 V

Wide-range input No

Overvoltage resistance 2.3 × Vin rated, 1.3 ms

Mains buffering at Iout rated, min. 20 ms

Mains buffering at Vin = 93/187 V

Rated line frequency 50 / 60 Hz

Rated line range 47 ... 63 Hz

Input current / at nominal level of the input voltage 120 V 4.1 A

Input current / at nominal level of the input voltage 230 V 2.4 A

Switch-on current limiting (+25 °C), max. 65 A

Duration of current limiting / at 25 °C / typical 3 ms

6EP1334-1LB00

Page 1/ 05/19/2014

subject to modifications

Summary of content (4 pages)

PAGE 1
Product data sheet 6EP1334-1LB00 SITOP PSU100L 24 V/10 A STABILIZED POWER SUPPLY INPUT: 120/230 V AC OUTPUT: 24 V/10 A DC Technical specifications Product SITOP PSU100L Power supply, type 24 V/10 A Input Input 1-phase AC Supply voltage / 1 / at AC / nominal value 120 V Supply voltage / 2 / at AC / nominal value 230 V Voltage range • Note Set by means of selector switch on the device Input voltage / 1 / at AC 93 … 132 V Input voltage / 2 / at AC 187 … 264 V Wide-range input No Overvoltage
PAGE 2
I²t, max. 3.3 A²·s Built-in incoming fuse T 6.3 A/250 V (not accessible) Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: from 10 A characteristic C Output Output Controlled, isolated DC voltage Rated voltage Vout DC 24 V Total tolerance, static ± 3% Static mains compensation, approx. 0.1 % Static load balancing, approx. 0.5 % Residual ripple peak-peak, max. 150 mV Residual ripple peak-peak, typ. 50 mV Spikes peak-peak, max.
PAGE 3
Enduring short circuit current / Effective level / typical 16 A Overload/short-circuit indicator - Safety Primary/secondary isolation Yes Potential separation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 Protection class Class I stray current / maximum 3.5 mA stray current / typical 0.8 mA CE mark Yes UL/CSA approval Yes UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 107.
PAGE 4
Mounting type / wall mounting No Type of mounting / standard rail mounting Yes Mounting type / S7-300 rail mounting No Installation Snaps onto DIN rail EN 60715 35x7.