Datasheet

ManualsBrandsSIEMENS ManualsRack & DIN Rail Mount PSUsRail mounted PSU (DIN) 12 Vdc 4.5 A 54 W 1 x

Data sheet 6EP3322-6SB00-0AY0

LOGO!POWER 12 V/4.5 A

LOGO!POWER 12 V / 4.5 A Regulated power supply input: 100-240

V AC output: 12 V DC/ 4.5 A

Input

Input 1-phase AC or DC

Rated voltage value Vin rated 100...240V

Voltage range AC 85...264V

Input voltage

● at DC

110...300V

Wide-range input Yes

Overvoltage resistance 300 V AC for 1 s

Mains buffering at Iout rated, min. 40ms; at Vin = 187 V

Rated line frequency 1 50Hz

Rated line frequency 2 60Hz

Rated line range 47...63Hz

Input current

● at rated input voltage 120 V

1.13A

● at rated input voltage 230 V

0.61A

Switch-on current limiting (+25 °C), max. 50A

I²t, max. 3A²·s

Built-in incoming fuse internal

6EP3322-6SB00-0AY0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6EP3322-6SB00-0AY0 LOGO!POWER 12 V/4.5 A LOGO!POWER 12 V / 4.5 A Regulated power supply input: 100-240 V AC output: 12 V DC/ 4.5 A Input Input 1-phase AC or DC Rated voltage value Vin rated 100 ... 240 V Voltage range AC 85 ... 264 V Input voltage ● at DC 110 ... 300 V Wide-range input Yes Overvoltage resistance 300 V AC for 1 s Mains buffering at Iout rated, min. 40 ms; at Vin = 187 V Rated line frequency 1 50 Hz Rated line frequency 2 60 Hz Rated line range 47 ...
PAGE 2
Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: from 10 A characteristic B or from 6 A characteristic C Output Output Controlled, isolated DC voltage Rated voltage Vout DC 12 V Total tolerance, static ± 3% Static mains compensation, approx. 0.1 % Static load balancing, approx. 0.1 % Residual ripple peak-peak, max. 200 mV Residual ripple peak-peak, typ. 30 mV Spikes peak-peak, max. (bandwidth: 20 MHz) 300 mV Spikes peak-peak, typ.
PAGE 3
Enduring short circuit current RMS value ● maximum 5A Overcurrent overload capability in normal operation overload capability 150% Iout rated typ. 200 ms Overload/short-circuit indicator - measuring point for output current 50 mV =^ 4.5 A Safety Primary/secondary isolation Yes Galvanic isolation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 Protection class Class II (without protective conductor) CE mark Yes UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No.
PAGE 4
● top 20 mm ● bottom 20 mm ● left 0 mm ● right 0 mm Weight, approx. 0.2 kg Product feature of the enclosure housing for side-byside mounting Yes Installation Snaps onto DIN rail EN 60715 35x7.