Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCsPLC inou module 6ES7131-6BF00-0DA0

Data sheet 6ES7131-6BF00-0DA0

SIMATIC ET 200SP, digital input module, DI 8x 24 V DC High

Speed, Pack quantity: 1 unit, three alternative operating modes: DI,

Oversampling, 4x counters, suitable for BU type A0, Color code

CC01

General information

Product type designation DI 8x24 V DC HS

HW functional status from FS04

Firmware version V1.0.2

● FW update possible

Yes

usable BaseUnits BU type A0

Color code for module-specific color identification

plate

CC01

Product function

● I&M data

Yes; I&M0 to I&M3

Engineering with

● STEP 7 TIA Portal configurable/integrated as of

version

V13 SP1

● STEP 7 configurable/integrated as of version

V5.5 SP3 / -

● PROFIBUS as of GSD version/GSD revision

GSD Revision 5

● PROFINET as of GSD version/GSD revision

GSDML V2.3

Operating mode

● DI

Yes

● Counter

Yes

6ES7131-6BF00-0DA0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6ES7131-6BF00-0DA0 SIMATIC ET 200SP, digital input module, DI 8x 24 V DC High Speed, Pack quantity: 1 unit, three alternative operating modes: DI, Oversampling, 4x counters, suitable for BU type A0, Color code CC01 General information Product type designation DI 8x24 V DC HS HW functional status from FS04 Firmware version V1.0.
PAGE 2
● Oversampling Yes ● MSI No Supply voltage Rated value (DC) 24 V permissible range, lower limit (DC) 19.2 V permissible range, upper limit (DC) 28.8 V Reverse polarity protection Yes Input current Current consumption, max. 70 mA; without sensor supply Encoder supply 24 V encoder supply ● 24 V Yes ● Short-circuit protection Yes; per module, electronic ● Output current, max. 700 mA Power loss Power loss, typ. 1.5 W Address area Address space per module ● Address space per module, max.
PAGE 3
— Counting width 32 bit — Counting direction up/down Yes ● Digital input with oversampling Yes — Number, max. 8 — Values per cycle, max. 32 — Resolution, min. 7.8125 µs Input voltage ● Rated value (DC) 24 V ● for signal "0" -30 to +5V ● for signal "1" +11 to +30V Input current ● for signal "1", typ. 6 mA Input delay (for rated value of input voltage) for standard inputs — parameterizable Yes; none / 0.05 / 0.1 / 0.4 / 0.8 / 1.6 / 3.2 / 12.
PAGE 4
● Monitoring of encoder power supply Yes; Module-wise ● Wire-break No ● Short-circuit Yes; Module-wise Diagnostics indication LED ● Monitoring of the supply voltage (PWR-LED) Yes; Green PWR LED ● Channel status display Yes; Green LED ● for channel diagnostics No ● for module diagnostics Yes; green/red DIAG LED Potential separation Potential separation channels ● between the channels No ● between the channels and backplane bus Yes ● between the channels and the power supply of the electroni