Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCsPLC output module 6ES7132-6FD00-2BB1

Data sheet 6ES7132-6FD00-2BB1

SIMATIC ET 200SP, digital output module, DQ 4x 24..230V AC/2A

Standard Pack quantity: 10 units, suitable for BU type B1, Color code

CC41, Module diagnostics

General information

Product type designation DQ 4x24 ... 230 V AC/2 A ST

HW functional status From FS05

Firmware version V1.0

● FW update possible

Yes

usable BaseUnits BU type B1

Color code for module-specific color identification

plate

CC41

Product function

● I&M data

Yes; I&M0 to I&M3

Engineering with

● STEP 7 TIA Portal configurable/integrated as of

version

V13 / V13

● STEP 7 configurable/integrated as of version

V5.5 SP3 / -

● PROFIBUS as of GSD version/GSD revision

GSD Revision 5

● PROFINET as of GSD version/GSD revision

GSDML V2.3

Operating mode

● DQ

Yes

● DQ with energy-saving function

6ES7132-6FD00-2BB1 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6ES7132-6FD00-2BB1 SIMATIC ET 200SP, digital output module, DQ 4x 24..230V AC/2A Standard Pack quantity: 10 units, suitable for BU type B1, Color code CC41, Module diagnostics General information Product type designation DQ 4x24 ... 230 V AC/2 A ST HW functional status From FS05 Firmware version V1.
PAGE 2
● PWM No ● Oversampling No ● MSO No Supply voltage Rated value (AC) 230 V permissible range, lower limit (AC) 20.4 V permissible range, upper limit (AC) 264 V Input current Current consumption (rated value) 11.5 mA Output voltage Rated value (AC) 230 V; 24V AC to 230V AC Power loss Power loss, typ. 9 W; Active power, load voltage 230 V, all outputs loaded with 2 A, 50 Hz Address area Address space per module ● Address space per module, max.
PAGE 3
Output current ● for signal "1" rated value 2A ● for signal "1" permissible range, min. 10 mA ● for signal "1" permissible range, max. 2A ● for signal "0" residual current, max. 460 µA Output delay with resistive load ● "0" to "1", max. 10 ms ● "1" to "0", max. 10 ms Parallel switching of two outputs ● for logic links No ● for uprating No ● for redundant control of a load Yes Switching frequency ● with resistive load, max. 10 Hz ● with inductive load, max. 0.
PAGE 4
● Monitoring the supply voltage No ● Wire-break No ● Short-circuit No ● Group error Yes Diagnostics indication LED ● Monitoring of the supply voltage (PWR-LED) Yes; Green PWR LED ● Channel status display Yes; Green LED ● for channel diagnostics No ● for module diagnostics Yes; green/red DIAG LED Potential separation Potential separation channels ● between the channels No ● between the channels and backplane bus Yes ● between the channels and the power supply of the electronics No Isola