Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6ES7134-4NB01-0AB0 PLC electronics board

Data sheet 6ES7134-4NB01-0AB0

SIMATIC DP, Electronics module f. ET200S, 2AI TC High Feature,

15 mm width, 15 bit+sign with internal temperature Compensation

Supply voltage

Load voltage L+

● Rated value (DC)

24V; From power module

● Reverse polarity protection

Yes

Input current

from load voltage L+ (without load), max. 30mA

from backplane bus 3.3 V DC, max. 10mA

Power loss

Power loss, typ. 0.6W

Address area

Address space per module

● Address space per module, max.

4byte

Analog inputs

Number of analog inputs 2

permissible input voltage for voltage input

(destruction limit), max.

20V; ±20 V, continuous

Cycle time (all channels) max. Number of active channels per module x basic conversion time

6ES7134-4NB01-0AB0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6ES7134-4NB01-0AB0 SIMATIC DP, Electronics module f. ET200S, 2AI TC High Feature, 15 mm width, 15 bit+sign with internal temperature Compensation Supply voltage Load voltage L+ ● Rated value (DC) 24 V; From power module ● Reverse polarity protection Yes Input current from load voltage L+ (without load), max. 30 mA from backplane bus 3.3 V DC, max. 10 mA Power loss Power loss, typ. 0.6 W Address area Address space per module ● Address space per module, max.
PAGE 2
Technical unit for temperature measurement adjustable Yes; Celsius / Fahrenheit Input ranges (rated values), voltages ● -80 mV to +80 mV Yes ● Input resistance (-80 mV to +80 mV) 1 MΩ Input ranges (rated values), thermocouples ● Type B Yes ● Input resistance (Type B) 1 MΩ ● Type C Yes ● Input resistance (Type C) 1 MΩ ● Type E Yes ● Input resistance (Type E) 1 MΩ ● Type J Yes ● Input resistance (type J) 1 MΩ ● Type K Yes ● Input resistance (Type K) 1 MΩ ● Type L Yes ● Input resist
PAGE 3
● Interference voltage suppression for interference frequency f1 in Hz 50 / 60 Hz ● Conversion time (per channel) 66 ms; 66 / 80 ms; additional conversion time for diagnostic wire break test Smoothing of measured values ● parameterizable Yes; In four stages by means of digital filtering ● Step: None Yes; 1x cycle time ● Step: low Yes; 4x cycle time ● Step: Medium Yes; 32x cycle time ● Step: High Yes; 64x cycle time Errors/accuracies Linearity error (relative to input range), (+/-) 0.
PAGE 4
Measurement type/range Deactivated/ ±80 mV/ TC-EL Type T (Cu-CuNi)/ TC-EL Type K (NiCr-Ni)/ TC-EL Type B (PtRh-PtRh)/ TC-EL Type c (Wer-Wer) TC-EL Type N (NiCrSi-NiSi)/ TC-EL Type E (NiCr-CuNi)/ TC-EL Type R (PtRh-Pt)/ TC-EL Type S (PtRh-Pt)/ TC-EL Type J (FeCu-Ni)/ TC Group diagnostics Disable / enable Overflow/underflow Disable / enable Comparison point none / yes, internal Potential separation Potential separation analog inputs ● between the channels No ● between the channels and backplane bus