Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6ES7134-6FF00-0AA1 PLC inou module

Data sheet 6ES7134-6FF00-0AA1

SIMATIC ET 200SP, Analog input module, AI 8XU Basic, suitable for

BU type A0, A1, Color code CC02, Module diagnostics, 16 bit

General information

Product type designation AI 8xU BA

HW functional status from FS04

Firmware version

● FW update possible

Yes

usable BaseUnits BU type A0, A1

Color code for module-specific color identification

plate

CC02

Product function

● I&M data

Yes; I&M0 to I&M3

● Measuring range scalable

Engineering with

● STEP 7 TIA Portal configurable/integrated as of

version

V13 SP1

● STEP 7 configurable/integrated as of version

V5.5 SP3 / -

● PROFIBUS as of GSD version/GSD revision

GSD Revision 5

● PROFINET as of GSD version/GSD revision

GSDML V2.3

Operating mode

● Oversampling

6ES7134-6FF00-0AA1 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6ES7134-6FF00-0AA1 SIMATIC ET 200SP, Analog input module, AI 8XU Basic, suitable for BU type A0, A1, Color code CC02, Module diagnostics, 16 bit General information Product type designation AI 8xU BA HW functional status from FS04 Firmware version ● FW update possible Yes usable BaseUnits BU type A0, A1 Color code for module-specific color identification plate CC02 Product function ● I&M data Yes; I&M0 to I&M3 ● Measuring range scalable No Engineering with ● STEP 7 TIA Portal conf
PAGE 2
● MSI No CiR – Configuration in RUN Reparameterization possible in RUN Yes Calibration possible in RUN No Supply voltage Rated value (DC) 24 V permissible range, lower limit (DC) 19.2 V permissible range, upper limit (DC) 28.8 V Reverse polarity protection Yes Input current Current consumption, max. 25 mA Power loss Power loss, typ. 0.7 W Address area Address space per module ● Address space per module, max.
PAGE 3
● Conversion time (per channel) 180 / 60 / 50 / 0.625 (67.5 / 22.5 / 18.75) ms Smoothing of measured values ● Number of smoothing levels 4; None; 4/8/16 times ● parameterizable Yes Encoder Connection of signal encoders ● for voltage measurement Yes ● for current measurement as 4-wire transducer No Errors/accuracies Linearity error (relative to input range), (+/-) 0.01 % Temperature error (relative to input range), (+/-) 0.005 %/K Crosstalk between the inputs, min.
PAGE 4
Potential separation channels ● between the channels No ● between the channels and backplane bus Yes ● between the channels and the power supply of the electronics No Isolation Isolation tested with 707 V DC (type test) Ambient conditions Ambient temperature during operation ● horizontal installation, min. -30 °C ● horizontal installation, max. 60 °C ● vertical installation, min. -30 °C ● vertical installation, max.