Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6ES7145-6HD00-0AB0 PLC add-on module

Data sheet 6ES7145-6HD00-0AB0

SIMATIC DP, ET 200ECO PN, 4 AO U/I; 4xM12, Degree of

protection IP67

General information

Vendor identification (VendorID) 002AH

Device identifier (DeviceID) 0306H

Supply voltage

Rated value (DC) 24V

Reverse polarity protection Yes

Input current

Current consumption, typ. 280mA

Actuator supply

Number of outputs 4

Short-circuit protection Yes; Electronic at 1.4 A

Output current

● Rated value

1A; Maximum

Power loss

Power loss, typ. 5.5W

Analog outputs

Number of analog outputs 4

6ES7145-6HD00-0AB0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6ES7145-6HD00-0AB0 SIMATIC DP, ET 200ECO PN, 4 AO U/I; 4xM12, Degree of protection IP67 General information Vendor identification (VendorID) 002AH Device identifier (DeviceID) 0306H Supply voltage Rated value (DC) 24 V Reverse polarity protection Yes Input current Current consumption, typ. 280 mA Actuator supply Number of outputs 4 Short-circuit protection Yes; Electronic at 1.4 A Output current ● Rated value 1 A; Maximum Power loss Power loss, typ. 5.
PAGE 2
Voltage output, short-circuit protection Yes Voltage output, short-circuit current, max. 30 mA Current output, no-load voltage, max. 20 V Output ranges, voltage ● 0 to 10 V Yes ● 1 V to 5 V Yes ● -10 V to +10 V Yes Output ranges, current ● 0 to 20 mA Yes ● -20 mA to +20 mA Yes ● 4 mA to 20 mA Yes Connection of actuators ● for voltage output two-wire connection Yes ● for current output two-wire connection Yes Load impedance (in rated range of output) ● with voltage outputs, min.
PAGE 3
Interfaces Transmission procedure 100BASE-TX Number of PROFINET interfaces 1 1. Interface Interface types ● integrated switch Yes ● M12 port Yes Interface types M12 port ● Transmission procedure 100BASE-TX ● Autonegotiation Yes ● Autocrossing Yes ● Transmission rate, max.
PAGE 4
between the load voltages Yes between load voltage and all other switching components No between Ethernet and electronics Yes Potential separation channels ● between the channels No Permissible potential difference between M internally and the outputs 10 Vpp AC Isolation tested with ● 24 V DC circuits 707 V DC (type test) ● Test voltage for interface, rms value [Vrms] 1 500 V; According to IEEE 802.