User Manual

Getting started
3.4 Use the PLC tags in the tag table for addressing the instructions
Easy Book
Manual, 03/2014, A5E02486774-AF
43
3.4
Use the PLC tags in the tag table for addressing the instructions
Using the tag table, you can quickly enter the PLC tags for the addresses of the contacts and
coils.
1.
Double-click the default address
<
??.?> above the first normally
open contact.
2.
Click the selector icon to the right
of the address to open the tags in
the tag table.
3.
From the drop-down list, select
"Start" for the first contact.
4.
For the second contact, repeat the
preceding steps and select the tag
"Stop".
5.
For the coil and the latching
contact, select the tag "Running".
You can also drag the I/O addresses directly
from the CPU. Simply
split the work area of the
Project view
(Page 34).
You must zoom the CPU to over 200% in order
to select the I/O points.
You can drag the I/O on the CPU in the "Device
configuration" to the LAD instruction in the
program editor to create not only the address for
the instruction, but also to create a
n entry in the
PLC tag table.