User Manual

Easy to communicate between devices
7.6 PROFIBUS
Easy Book
146 Manual, 03/2014, A5E02486774-AF
Next, select "6ES7 151-1BA02-0AB0" (IM151-1 HF) from the list of part numbers, and add
the ET200 S DP slave as shown in the figure below.
Table 7- 8 Adding an ET200 S DP slave to the device configuration
Insert the DP slave
Result
7.6.4
Assigning PROFIBUS addresses to the CM 1243-5 module and DP slave
Configuring the PROFIBUS interface
After you configure logical network connections between two PROFIBUS devices, you can
configure parameters for the PROFIBUS interfaces. To do so, click the purple PROFIBUS
box on the CM 1243-5 module, and the "Properties" tab in the inspector window displays the
PROFIBUS interface. The DP slave PROFIBUS interface is configured in the same manner.
Table 7- 9 Configuring the CM 1243-5 (DP master) module and ET200 S DP slave PROFIBUS
interfaces
CM 1243-5 (DP master) module
ET200 S DP slave
① PROFIBUS port