Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6ES7522-1BF00-0AB0 PLC digital ouput module

Data sheet 6ES7522-1BF00-0AB0

SIMATIC S7-1500, digital output module DQ 8x24 V DC/2A HF; 8

channels in groups of 8; 8 A per group; Diagnostics, substitute value:

Front connector (screw terminals or push-in) to be ordered

separately

General information

HW functional status FS03

Firmware version V2.2.0

● FW update possible

Yes

Product function

● I&M data

Yes; I&M0 to I&M3

Engineering with

● STEP 7 TIA Portal configurable/integrated as of

version

V13 SP1 / -

● STEP 7 configurable/integrated as of version

V5.5 SP3 / -

● PROFIBUS as of GSD version/GSD revision

V1.0 / V5.1

● PROFINET as of GSD version/GSD revision

V2.3 / -

Operating mode

● DQ

Yes

● DQ with energy-saving function

Yes; with an application

● PWM

Yes

● Cam control (switching at comparison values)

6ES7522-1BF00-0AB0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6ES7522-1BF00-0AB0 SIMATIC S7-1500, digital output module DQ 8x24 V DC/2A HF; 8 channels in groups of 8; 8 A per group; Diagnostics, substitute value: Front connector (screw terminals or push-in) to be ordered separately General information HW functional status FS03 Firmware version V2.2.
PAGE 2
● Oversampling No ● MSO Yes ● Integrated operating cycle counter Yes Supply voltage Rated value (DC) 24 V permissible range, lower limit (DC) 20.4 V permissible range, upper limit (DC) 28.8 V Reverse polarity protection Yes; through internal protection with 10 A per group Input current Current consumption, max. 40 mA; 20 mA per group, no output is activated. Output voltage Rated value (DC) 24 V Power Power available from the backplane bus 0.9 W Power loss Power loss, typ. 5.6 W; 6.
PAGE 3
● for signal "1", min. L+ (-0.8 V) Output current ● for signal "1" rated value 2A ● for signal "1" permissible range, max. 2.4 A; Note derating specification for PWM operation ● for signal "0" residual current, max. 0.5 mA Output delay with resistive load ● "0" to "1", typ. 80 µs ● "0" to "1", max. 100 µs ● "1" to "0", typ. 300 µs ● "1" to "0", max.
PAGE 4
● RUN LED Yes; Green LED ● ERROR LED Yes; Red LED ● MAINT LED Yes; Yellow LED ● Monitoring of the supply voltage (PWR-LED) Yes; Green LED ● Channel status display Yes; Green LED ● for channel diagnostics Yes; Red LED ● for module diagnostics Yes; Red LED Potential separation Potential separation channels ● between the channels No ● between the channels, in groups of 4 ● between the channels and backplane bus Yes Isolation Isolation tested with 707 V DC (type test) Standards, approvals,