Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6ES7534-7QE00-0AB0 PLC analogue I/O module

Data sheet 6ES7534-7QE00-0AB0

SIMATIC S7-1500 Analog input/output module AI 4x U/I/R/RTD/TC

ST; 4 channels in groups of 4; Hardware interrupts; Diagnostics AQ

2x U/I ST; 2 channels in groups of 2; Substitute value; Diagnostics

Common mode voltage approx. 10 V 16 bit; Accuracy 0.3%; Delivery

including push-in front connector, infeed element, shield bracket and

shield terminal

General information

Product type designation AI 4xU/I/RTD/TC /AQ 2xU/I ST

HW functional status FS01

Firmware version V1.0.0

● FW update possible

Yes

Product function

● I&M data

Yes; I&M0 to I&M3

● Measuring range scalable

● Scalable measured values

● Adjustment of measuring range

● Output range scalable

Engineering with

● STEP 7 TIA Portal configurable/integrated as of

version

V13 / V13.0.2

● STEP 7 configurable/integrated as of version

V5.5 SP3 / -

● PROFIBUS as of GSD version/GSD revision

V1.0 / V5.1

● PROFINET as of GSD version/GSD revision

V2.3 / -

Operating mode

● Oversampling

6ES7534-7QE00-0AB0 Subject to change without notice

Page 1/

Summary of content (9 pages)

PAGE 1
Data sheet 6ES7534-7QE00-0AB0 SIMATIC S7-1500 Analog input/output module AI 4x U/I/R/RTD/TC ST; 4 channels in groups of 4; Hardware interrupts; Diagnostics AQ 2x U/I ST; 2 channels in groups of 2; Substitute value; Diagnostics Common mode voltage approx. 10 V 16 bit; Accuracy 0.3%; Delivery including push-in front connector, infeed element, shield bracket and shield terminal General information Product type designation AI 4xU/I/RTD/TC /AQ 2xU/I ST HW functional status FS01 Firmware version V1.0.
PAGE 2
● MSI Yes ● MSO Yes CiR – Configuration in RUN Reparameterization possible in RUN Yes Calibration possible in RUN Yes Supply voltage Type of supply voltage DC Rated value (DC) 24 V permissible range, lower limit (DC) 20.4 V permissible range, upper limit (DC) 28.8 V Reverse polarity protection Yes Input current Current consumption, max. 200 mA; with 24 V DC supply Encoder supply 24 V encoder supply ● Short-circuit protection Yes ● Output current, max. 20 mA; Max.
PAGE 3
● 0 to +10 V No ● 1 V to 5 V Yes ● Input resistance (1 V to 5 V) 100 kΩ ● -1 V to +1 V Yes ● Input resistance (-1 V to +1 V) 10 MΩ ● -10 V to +10 V Yes ● Input resistance (-10 V to +10 V) 100 kΩ ● -2.5 V to +2.5 V Yes ● Input resistance (-2.5 V to +2.
PAGE 4
● Input resistance (Type R) 10 MΩ ● Type S Yes ● Input resistance (Type S) 10 MΩ ● Type T Yes ● Input resistance (Type T) 10 MΩ ● Type U No ● Type TXK/TXK(L) to GOST No Input ranges (rated values), resistance thermometer ● Cu 10 No ● Cu 10 according to GOST No ● Cu 50 No ● Cu 50 according to GOST No ● Cu 100 No ● Cu 100 according to GOST No ● Ni 10 No ● Ni 10 according to GOST No ● Ni 100 Yes; Standard/climate ● Input resistance (Ni 100) 10 MΩ ● Ni 100 according to GOST No
PAGE 5
● Input resistance (Pt 200) 10 MΩ ● Pt 200 according to GOST No ● Pt 500 Yes; Standard/climate ● Input resistance (Pt 500) 10 MΩ ● Pt 500 according to GOST No Input ranges (rated values), resistors ● 0 to 150 ohms Yes ● Input resistance (0 to 150 ohms) 10 MΩ ● 0 to 300 ohms Yes ● Input resistance (0 to 300 ohms) 10 MΩ ● 0 to 600 ohms Yes ● Input resistance (0 to 600 ohms) 10 MΩ ● 0 to 3000 ohms No ● 0 to 6000 ohms Yes ● Input resistance (0 to 6000 ohms) 10 MΩ ● PTC Yes ● Input
PAGE 6
● 4 mA to 20 mA Yes Connection of actuators ● for voltage output two-wire connection Yes ● for voltage output four-wire connection Yes ● for current output two-wire connection Yes Load impedance (in rated range of output) ● with voltage outputs, min. 1 kΩ; 0.5 kOhm at 1 to 5 V ● with voltage outputs, capacitive load, max. 1 µF ● with current outputs, max. 750 Ω ● with current outputs, inductive load, max. 10 mH Cable length ● shielded, max.
PAGE 7
Encoder Connection of signal encoders ● for voltage measurement Yes ● for current measurement as 2-wire transducer Yes — Burden of 2-wire transmitter, max.
PAGE 8
● Resistance thermometer, relative to input range, (+/-) 0.1 %; Ptxxx standard: ±0.7 K, Ptxxx climate: ±0.2 K, Nixxx standard: ±0.3 K, Nixxx climate: ±0.15 K ● Thermocouple, relative to input range, (+/-) 0.1 %; Type B: > 600 °C ±1.7 K, type E: > -200 °C ±0.7 K, type J: > -210 °C ±0.8 K, type K: > -200 °C ±1.2 K, type N: > -200 °C ±1.2 K, type R: > 0 °C ±1.9 K, type S: > 0 °C ±1.9 K, type T: > -200 °C ±0.8 K ● Voltage, relative to output range, (+/-) 0.
PAGE 9
● between the channels No ● between the channels, in groups of 2 ● between the channels and backplane bus Yes ● Between the channels and load voltage L+ Yes Permissible potential difference between the inputs (UCM) 20 V DC Between the inputs and MANA (UCM) 10 V DC between S- and MANA (UCM) 8 V DC Isolation Isolation tested with 707 V DC (type test) Ambient conditions Ambient temperature during operation ● horizontal installation, min. 0 °C ● horizontal installation, max.