User Manual

Programming LOGO!
3.8 Configuring additional functions for LOGO!
LOGO!
104 Manual, 06/2014, A5E33039675
5. Move the cursor to ③": Press or
6. Confirm "
③": Press
OK
7. In this view, you enter the IP address of the LOGO! that you want to configure to be the
master of your slave LOGO!. To change the setting, press
OK
. When the cursor appears
in a flashing solid square, press
or to move the cursor through the numbers. Press
or
to change the number.
8. Confirm the setting: Press
OK
You have now successfully changed LOGO! from master mode to slave mode. LOGO!
restarts automatically and then displays the main menu. Stepping into the following view,
you can see that your LOGO! is now in slave mode:
Note
When LOGO! is in slave mode, you can not edit the circuit program from the slave LOGO!.
You cannot change LOGO! to master/slave mode in parameter assignment mode.
Changing LOGO! from slave mode to master mode
LOGO! is now in slave mode:
1. Move the cursor to "①": Press or
2. Confirm "
①": Press
OK
You have now successfully changed LOGO! from slave mode to master mode. LOGO!
restarts automatically and then displays the main menu.