User Manual

Programming LOGO!
3.9 Memory space and circuit program size
LOGO!
Manual, 06/2014, A5E33039675
109
5. To enter an IP address, Press
OK
. When the cursor appears in a flashing solid square,
press
or to move the cursor to a position where you want to modify the number, then
press
or to increase or decrease the number.
6. Press
OK
to confirm your input.
LOGO! stores up to four addresses that you entered previously. To view your last inputs,
press
to move the cursor to the " " symbol, and then press
OK
to open a drop-down
list, for example:
You can press
or to select a previously configured address in the list, and then press
OK
to comfirm.
Toggling an error alert
You can enable/disable an error alert by following these steps:
1. In the diagnostic menu shown below, move the cursor to "
①": Press or
2. Confirm "
①": Press
OK
3. The circle with a dot indicates the current setting. To change the setting: Press
or
4. Confirm your selection: Press
OK
. LOGO! returns to the previous view.
If you enable the error alert, when an error occurs, the LOGO! display turns to red backlight,
reminding you that LOGO! detects an error. You can go to the diagnostics menu to view and
clear the error.
3.9
Memory space and circuit program size
The size of a circuit program in LOGO! is limited by the memory space.
Memory areas
●
Program memory
:
LOGO! allows only a limited number of blocks in your circuit program.