User Manual

LOGO! functions
4.4 Special functions list - SF
LOGO!
Manual, 06/2014, A5E33039675
151
● Analog multiplexer (Page 213) (actual value AQ)
● Analog ramp (Page 216) (actual value AQ)
● Mathematic instruction (Page 227) (actual value AQ)
● PI controller (Page 220) (actual value AQ)
● Up/down counter (Page 173) (actual value Cnt)
● Analog filter (Page 232) (actual value AQ)
● Average value (Page 237) (actual value AQ)
● Max/Min (Page 234) (actual value AQ)
● On-delay (Page 136) (current time Ta)
● Off-delay (Page 140) (current time Ta)
● On-/off-delay (Page 142) (current time Ta)
● Retentive on-delay (Page 144) (current time Ta)
● Wiping relay(pulse output) (Page 146) (current time Ta)
● Edge triggered wiping relay (Page 148) (current time Ta)
● Aysnchronous pulse generator (current time Ta)
● Stairway light switch (Page 154) (current time Ta)
● Multiple function switch (Page 156) (current time Ta)
● Stopwatch (Page 171) (actual value AQ)
● Threshold trigger (Page 180) (actual value Fre)
Select the required function by the block number. The timebase is configurable. For
information on valid ranges and parameter defaults, refer to the On-delay (Page 136) topic.
Timing diagram
Functional description
You can configure the pulse/interpulse width at the T
H
(Time High) and T
L
(Time Low)
parameters.
Input Inv can be used to invert the output signal, provided the block is enabled with a signal
at input EN.
If the block is retentive, LOGO! resets output Q and the expired time to the values before a
power failure; if the block is not retentive, LOGO! resets output Q and the expired time to
defaults after a power failure.