User Manual

LOGO! functions
4.4 Special functions list - SF
LOGO!
Manual, 06/2014, A5E33039675
205
The screen display alternates between the two message halves every second.
You can configure each individual line of a message text to tick or not tick. The "character by
character" or "line by line" setting applies to all lines that you configure to tick.
Setting the Par parameter
From the input P, you configure the following characteristics of the message text:
● Priority
● Acknowledgement
● Message destination
● Tick type, and tick setting for each line
View in programming mode:
1. Press to position the cursor on the "ACK" line.
2. Press
OK.
Enable "Ack": Press or
3. Position the cursor on the "Msg Text" line by pressing
. Press
OK
twice. To select a line
for the message text, press
and . LOGO! shows as follows:
4. Press
and to select the letter to be displayed in the text. To move the cursor from one
position to another, press
and .
Note
The list of available characters is the same as for the circuit program name. The
character set is found in topic
Circuit program input (Page 69). When you enter message
text from LOGO!
Basic, you can only enter characters from the ISO8859-1 character set.
To enter text f
rom another language, you must enter the text in LOGO!Soft Comfort.
Note that the number of characters per line of message text can be greater than the
number of character positions on the LOGO! onboard display.
5. Confirm your entries with
OK
.
6. Press
to position the cursor on the "Priority" line.