User Manual

LOGO! functions
4.4 Special functions list - SF
LOGO!
210 Manual, 06/2014, A5E33039675
If retentivity is not set, output Q is initialized after a power failure according to your
configuration at the "Start" parameter.
Setting the Par parameter
View in programming mode (example):
1. Position the cursor on "Par". Press
OK.
2. Press
to position the cursor on the "On" line.
3. Press
OK
. Select "Momentary pushbutton" or "Switch": Press or .
4. Press
to move the cursor to "Start" line.
5. To change the "Start" state: Press
or .
6. Confirm your entries with
OK.
View in parameter assignment mode (example):
Here, you can set or reset the "Switch" parameter (On/Off). When in RUN, LOGO! shows the
following display:
Let us assume you want to set "Switch" (On).
1. Press
OK
(the cursor is now positioned on "Off").
2. To change from "Off" to "On": Press
or .
3. Confirm your entries with
OK.