User Manual

LOGO!
Manual, 06/2014, A5E33039675
253
Data log
7
You can configure a maximum of one data log for your circuit program using LOGO!Soft
Comfort. The data log records process measurement variables for function blocks that you
configure for data logging. You can add the data log instruction to your circuit program as
you do with a function block.
If you configured the data log for your circuit program, after transferring the program from
LOGO!Soft Comfort to LOGO!, you can edit the elements connected to the data log block.
For a detailed description of configuration of the data log function in LOGO!Soft Comfort,
refer to the Online Help for LOGO!Soft Comfort. From the LOGO! Base Module, you can
only configure elements connected to the data log block.
Editing elements connected to the data log block
If your circuit program in LOGO! contains a data log block configured from LOGO!Soft
Comfort, you can edit elements connected to this data log as follows:
1. Switch to programming mode. Press
OK
twice to step into the following display of your
circuit program:
2. Move the cursor to "L1" by pressing
(The data log is identified with a "L1"). Press
OK
.
LOGO! shows the following display: