User Manual

LOGO!
Manual, 06/2014, A5E33039675
255
Configuring LOGO!
8
Parameter assignment refers to the configuration of the block parameters. You can set delay
times for time functions, the switching times of timers, counter threshold values, the
monitoring interval of an hours counter, the on and off thresholds of the trigger, and more.
You can configure the parameters:
● In programming mode
● In parameter assignment mode
Parameter assignment mode allows the editing of parameters without having to modify the
circuit program. This feature is available so that you can edit parameters without having to
change to programming mode. The advantage is that you can edit program parameters, but
the circuit program remains protected.
Note
In parameter assignment mode, LOGO! continues execution of the circuit program.
8.1
Selecting parameter assignment mode
Press ESC to access the parameter assignment mode:
For more information about the menu commands in parameter assignment mode, refer to
Section "LOGO! Basic (Page 323)".
Follow these steps to stop your circuit program and thus change to the main menu of
programming mode:
1. Move the cursor to "
①": Press or
2. Confirm "
①": Press
OK