User Manual

Configuring LOGO!
8.1 Selecting parameter assignment mode
LOGO!
Manual, 06/2014, A5E33039675
259
8.1.3
Modifying parameters
You first select the parameter you want to edit (Page 258).
You change the value of the parameter in the same way as you did in programming mode:
1. Move the cursor to the point at which you want to make the change: Press
or
2. To change this value: Press
or
3. To apply the value:
OK
Note
When changing the time parameter when the system is in RUN, you can also change the
timebase (s=seconds, m=minutes, h=hours). This does not apply if the time parameter
represents the result of another func
tion (for an example, see the "On-delay (Page 136)"
topic). In this case you can neither change the value nor the timebase. The current time is
re
set to zero when you change the timebase.
Current value of a time T
View of a time T in parameter assignment mode:
You can change the configured time T.