User Manual

Configuring LOGO!
8.2 Setting the default values for LOGO!
LOGO!
Manual, 06/2014, A5E33039675
265
4. Confirm "②": Press
OK
5. Move the cursor to "
③": Press or
6. Select "
③": Press or
7. Confirm "
③": Press
OK
8. Move the cursor to "
④" or "⑤": Press or
9. Confirm "
④" or "⑤": Press
OK
The default setting is that the backlight is not on. To set the backlight to always be on,
select "
⑤".
Setting the backlight choice in programming mode
If you want to set the backlight in programming mode, select menu command "①" in the
main menu, then menus "
②" and "③". You can now set the backlight as described earlier.
Note
The backlight lifetime of the LOGO!
TDE is 20000 hours.
You can change the backlight colors of the LOGO! onboard display or the LOGO! TDE by
means of some speci
al flags (M25, M26, M28 to M31). For more information, refer to section
"
Constants and connectors (Page 115)". If you use these special flags in your circuit
programs, the backlight setting through the above menu commands takes no effect.
8.2.3
Setting the menu language
The language of the LOGO! menus can be one of ten predefined languages:
German
English
French
Spanish
Italian
Chinese
Dutch
Turkish
Russian
Japanese