User Manual

Using memory cards
9.3 Copying data from LOGO! to the card
LOGO!
Manual, 06/2014, A5E33039675
275
9.3
Copying data from LOGO! to the card
Copying data from LOGO! to the card manually
To manually copy the circuit program to the micro SD card, follow the steps shown in the
illustration below:
Press OK. LOGO! starts copying the circuit program to the card.
If power fails while LOGO! is copying the circuit program, repeat the process after power-on.
Note
•
If the program is empty, a message will display on the screen to remind you the program
in LOGO! is empty.
•
The password of a protected circuit program in LOGO! also applies to the copied program
version on your card.
Copying data from LOGO! to the card automatically
LOGO!Soft Comfort provides an option for automatically copying the circuit program to the
micro SD card when transferring the circuit program to LOGO!. This option is available in the
dialog for PC->LOGO! transfer. If you select this option, LOGO!Soft Comfort transfers the
circuit program to LOGO! and to the micro SD card.
Note
To successfully copy the circuit program from LOGO! to the micro SD card, make sure that
the free memory spa
ce available on the micro SD card is at least 100 Kbytes.
Generating the data log on the micro SD card
If your circuit program in LOGO! includes a Data Log function block configured from
LOGO!Soft Comfort, you can save the data log in your LOGO! or on the micro SD card. If
there is a micro SD card inserted into the slot of your LOGO!, then when LOGO! switches