User Manual

Using memory cards
9.4 Copying data from the card to LOGO!
LOGO!
276 Manual, 06/2014, A5E33039675
from STOP to RUN, it attempts to copy the data log to the micro SD card; otherwise, LOGO!
saves the data log in memory. At every STOP to RUN transition, LOGO! determines the
destination of the data log storage.
If LOGO! copies the data log to the micro SD card, it saves the data log by default as .CSV
file format, which you can then open from a PC. Each line in the .CSV file includes a time
stamp, the function block number and the actual values recorded. For more information
about the data log, refer to Chapter "Data log (Page 253)".
Note
When LOGO! with an inserted micro SD card is in STOP mode, you can upload the most
recent data log file on the micro SD card to LOGO!Soft Comfort using a transfer menu
command in LOGO!Soft Comfort. For more information about the data log uploading
command
, refer to the Online Help for LOGO!Soft Comfort.
9.4
Copying data from the card to LOGO!
You can copy a circuit program from a micro SD card to LOGO! in one of the following ways:
● Automatically during the startup of LOGO! (POWER ON)
● By means of the card specific menu of LOGO!
Note
If the program on the card is protected with a password, the copied program in LOGO! is
also protected with the same password. For more information about the Card menu, refer to
Section "
Overview of LOGO! menus (Page 65)".
Automatic copying during the startup of LOGO!
To automatically copy the circuit program to the card, follow these steps:
1. Switch off the power supply to LOGO!.
2. Insert the card into the relevant slot.