User Manual

Using memory cards
9.4 Copying data from the card to LOGO!
LOGO!
Manual, 06/2014, A5E33039675
277
3. Switch on the power supply to LOGO!.
LOGO! copies the program from the program module/card to LOGO!. When LOGO!
finishes copying, it opens the LOGO! main menu:
Note
Before you switch LOGO! to RUN, you must ensure that the system you are cont
rolling
with LOGO! does not represent a source of hazard.
4. Move the cursor to the first menu command in Step 3: Press or .
5. Press OK.
Copying by means of the card specific menu
For more information about the replacement of a micro SD card, refer to Section "Inserting
and removing the card from LOGO! (Page 273)".
To copy a program from the card to LOGO!, insert the card and follow the steps shown in the
illustration below:
Press OK. LOGO! copies the circuit program from the card to LOGO!. When LOGO! has
finished copying, it automatically returns to the LOGO! main menu.