User Manual

LOGO! installation and wiring

2.1 Modular LOGO! setup

LOGO!

28 Manual, 06/2014, A5E33039675

are available. You can configure the static/dynamic connections as required, for example,

n static connections and 16-n dynamic connections. LOGO! supports a maximum of eight

static connections.

● A maximum of one TCP/IP Ethernet connection with the LOGO! TDE. A LOGO! TDE

module can connect with different Base Modules through IP address selection, but can

not communicate with more than one Base Module at the same time.

● A maximum of one TCP/IP Ethernet connection between a LOGO! Base Module and a

PC with LOGO!Soft Comfort V8.0 installed.

Note

You can only construct a LOGO! 0BA8 network topology using LOGO!Soft Comfort V8.0.

typical

LOGO! 0BA8 network setup is shown below:

①

Physical Ethernet connections

②

Logical connection for communication between LOGO! and PC (by TCP/IP-based Ethernet)

③

Logical connections for S7 communication between SIMATIC devices (with S7 protocol over TCP/IP)