User Manual

Security
10.3 Menu access security
LOGO!
282 Manual, 06/2014, A5E33039675
3. Move the cursor to "②": Press or
4. Confirm "
②" with
OK
.
LOGO! shows the following display:
By default, the card is unprotected.
5. Move the cursor to "
③": Press or
6. Confirm your selection by pressing
OK
.
Note
The
protection function applies only to the card; you must copy (Page 275) the circuit
program to the card in a separate action at power
-on.
You can a
lways change the status of protection function disabled to protection function
enabled.
A status change from protection function enabled to protection function disabled is only
possible if the card does not contain a circuit program.
10.3
Menu access security
LOGO! provides two access levels, administrator and operator, to limit access to specific
menus in programming mode.You can change LOGO!'s access level from administrator to
operator or from operator to administrator. For more information about switching between the
access levels, refer to Section "Configuring menu access protection for LOGO! (Page 63)".