User Manual

LOGO! installation and wiring
2.2 Installing/removing LOGO!
LOGO!
34 Manual, 06/2014, A5E33039675
Removal
To
remove
LOGO! if you have installed
only one
LOGO!
Base Module
, follow these steps:
1. Insert a screwdriver into the eyelet at the bottom of the slide interlock and move the latch
downward.
2. Swing the LOGO! Base Module off the DIN rail.
To
remove
LOGO! if you have connected
at least one expansion module
to the LOGO! Base
Module, follow these steps:
1. Using a screwdriver, push the integrated slide interlock to the right.
2. Slide the expansion module off towards the right.
3. Insert a screwdriver into the eyelet at the bottom of the slide interlock and lever it
downward.
4. Swing the expansion module off the profile rail.
Repeat steps 1 to 4 for all other expansion modules.
Note
When removing modules, be sure to disengage the slide interlock of the module that
connec
ts it to the next module. When removing multiple modules, it is easier to start with the
last module on the right side.