User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
66 Manual, 06/2014, A5E33039675
The LOGO! TDE provides three menus as follows:
● The remote IP selection menu
You can use this menu to select a connected Base Module by entering a specific IP
address.
● The Base Module setting menu
You can use this menu to perform the remote setting of the connected Base Module. This
menu has almost the same menu commands as those on the Base Modules, except for
the menu commands under "
①". The menu commands for setting the start screen,
message text, contrast and backlight, and menu language for the Base Module are not
available on the LOGO! TDE.
● The TDE configuration menu
You can use this menu to perform the independent configuration of the LOGO! TDE.
For more details on the menus, refer to the Appendix "LOGO! TDE (Page 329)".
3.7
Writing and starting the circuit program
The example below shows how to create a program for your circuit design in LOGO!.
3.7.1
Selecting programming mode
When you connect LOGO! to the power supply and switch it on, the display shows you the
main menu of the programming mode: