User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 06/2014, A5E33039675
75
5. Press or to move up and down the alphabet to select your letters. Because LOGO!
Basic only provides uppercase letters for the password, you can quickly access letters "at
the end" of the alphabet (in this example, English) by using the
button:
Press
once to select "
Z
"
Press
twice to select "
Y
", etc.
The display appears as follows:
To enter a password of "
AA
", for example, the procedure is the same as for entering the
name of the circuit program.
6. Select "
A
": Press
7. Move to the next letter: Press
8. Select "
A
": Press
The display now appears as follows:
9. Confirm the password: Press
OK
You have now protected your circuit program with the password "
AA
" and LOGO! returns to
the programming menu.
Note
You can cancel the input of a new password with ESC
. In this case, LOGO! Basic returns to
the programming menu without saving the password.
You can also set your password using LOGO!Soft Comfort or LOGO! TDE. You cann
ot edit
a password
-protected circuit program in a LOGO! Base Module or upload it to LOGO!Soft
Comfort unless you enter the correct password.
To allow you to create and edit a circuit program for a protected module (Card), you first
need to
assign a password to this new program (Page 281).