User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
78 Manual, 06/2014, A5E33039675
Password: Wrong Password!
If you enter the
wrong
password and confirm the input with
OK
, LOGO! Basic does not open
editing mode, and the display shows as follows:
In this case, press any key and LOGO! returns to the programming menu. This repeats itself
over and over again until you enter the correct password.
3.7.6
Switching LOGO! to RUN mode
To switch LOGO! to RUN mode, follow these steps:
1. Return to the main menu: Press
ESC
2. Move the cursor to "
①": Press or
3. Confirm "
①": Press
OK
. The display now shows:
4. Press
to move the cursor to "②" and press
OK
.
LOGO! runs the circuit program and shows the following display:
The start screen of LOGO! displays one of the following:
● Date and current time-of-day (only for versions with real-time clock). This element flashes
if you have not set the date and time.
● Digital inputs
● Parameter assignment menu
You can select the default setting for the start screen that LOGO! displays in RUN mode. For
more information, see Section "Setting the start screen (Page 267)".