User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 06/2014, A5E33039675
85
3. Press and to position the cursor.
4. Press
and to modify the value at the relevant position.
5. Confirm your entries with
OK
.
Setting the time
Set the time T = 12:00 minutes:
1. Move the cursor to the first digit: Press
or
2. Select the digit "1": Press
or
3. Shift the cursor to the second digit: Press
or
4. Select digit "2": Press
or
5. Move the cursor to the unit: Press
or
6. Select the timebase "m" (for minutes): Press
or
7. Confirm your entries with
OK
.
Showing/hiding parameters - the parameter protection mode
If you want to show/hide the parameter and allow/prevent its modification in parameter
assignment mode, follow these steps:
1. Move the cursor to "-/": Press
or
2. Switch to editing mode: Press
OK
3. Select the protection mode: Press
or
The display should now show:
4. Confirm your entries with
OK
.
Enabling/disabling retentivity
To decide whether you want to retain your current data after a power failure or not, follow
these steps:
1. Move the cursor to "-/": Press
or
2. Switch to editing mode: Press
OK
3. Move the cursor to the retentivity setting: Press
or