User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
86 Manual, 06/2014, A5E33039675
4. Select the retentivity setting: Press or
The display now shows:
5. Confirm your entries with
OK
.
Note
For further information on the protection mode, refer to the topic "
Parameter protection
(Page
129)".
For further information on retentivity, refer to the topic "
Retentivity (Page 129)".
You can modify the protection mode and retentivity setting only in programming mode. This
is not
possible in parameter assignment mode.
LOGO! displays protection mode ("+" or "
-") and retentivity ("R" or "/") settings only where
you can actually change these settings.
Verification of the circuit program
You have now completed the program branch for Q1 and LOGO! shows you the output Q1.
You can once again view the circuit program on the display. Use the keys to browse the
circuit program; that is, press
or to move from block to block, and to move between
the inputs at a block.
Closing the programming mode
When you finish programming, you can exit the programming mode by following these steps:
1. Return to the programming menu: Press
ESC
2. Return to the main menu: Press
ESC
3. Move the cursor to "
①": Press or
4. Confirm "
①": Press
OK
LOGO! is back in RUN mode: