User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 06/2014, A5E33039675
87
3.7.8
Deleting a block
Consider the case where you want to delete the block B2 from your circuit program and
connect B1 directly to Q1.
To delete this block, follow these steps:
1. Switch LOGO! to programming mode.
(As a reminder, refer to the topic "The four golden rules for operating LOGO! (Page 61)").
2. Select "
①": Press or
3. Confirm"
①": Press
OK
4. Select "
②": Press or
5. Confirm "
②": Press
OK
(If required, enter your password and confirm with
OK
.)
6. Press
OK
in the circuit program window, and the cursor now appears as a solid square.
7. Move the cursor to the Q1 block and then press
OK
.