User Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
90 Manual, 06/2014, A5E33039675
5. Move the cursor to "②": Press or
6. Select "
②": Press
OK
LOGO! shows the following display:
The circle with a dot before "
④" above indicates the current setting for the analog output
channels.
You can select either "
③" or "④". The default setting is "④" which means that LOGO!
holds the values of the analog outputs at their last values. A setting of "
③" means that
LOGO! sets the analog output values to specific values, which you can configure. When
LOGO! changes from RUN mode to STOP mode, the values of the analog outputs
change as well, depending on the setting.
7. Select the desired output setting: Press
or .
8. Confirm your entry: Press
OK.
Defining a specific analog output value
To output a specific analog value at the analog outputs, follow these steps:
1. Move the cursor to "
①": Press or
2. Confirm "
①": Press
OK
The display shows:
3. Select a desired analog output and press
OK
.