User Manual

Programming LOGO!

3.7 Writing and starting the circuit program

LOGO!

92 Manual, 06/2014, A5E33039675

3.7.13

Setting the power-on delay of LOGO!

You can set a power-on delay for LOGO! in order to make sure all the connected expansion

modules are powered on and ready to use before LOGO! runs the circuit programs.

To set the power-on delay, follow these steps:

1. In the programming menu, move the cursor to "

①": Press or

2. Confirm "

①": Press

3. Move the cursor to "

②": Press or

4. Confirm "

②": Press

. LOGO! shows the following display:

5. Press

or to increase or decrease the delay time by 0.2 s. You can also press and

hold down

or to quickly increase or decrease the time.

6. Confirm your setting: Press

3.7.14

Clearing the circuit program and password

To clear a circuit program and the password if one is defined, follow these steps:

1. Switch the LOGO! to programming mode. LOGO! opens the main menu:

2. On the main menu, press

or to move the cursor to "①". Press

. LOGO! opens the

programming menu.

3. On the programming menu, move the cursor to "

②": Press or