User Manual

Programming LOGO!
3.8 Configuring additional functions for LOGO!
LOGO!
Manual, 06/2014, A5E33039675
99
● Network digital outputs
● Network analog outputs
Note
If your circuit program in a LOGO! 0BA8 device contains any network digital or analog
inputs/outputs, you can only edit the "Par
" parameter of function blocks from LOGO!. You
can not edit any of the rest of the circuit program from the device.
3.8.1
Configuring network settings
A LOGO! 0BA8 device can establish network communication with other LOGO! 0BA8
devices, SIMATIC S7 PLCs, a SIMATIC HMI, or a PC with LOGO!Soft Comfort V8.0 (For
more detailed information, refer to the Maximum LOGO! network setup (Page 27) topic). You
can configure the LOGO! 0BA8 network only from LOGO!Soft Comfort V8.0 . From LOGO!
0BA8, you can configure your LOGO!'s network settings including IP address, subnet mask
and gateway.
Note
You can configure LOGO!'s network settings including IP adress, subnet mask and gateway
with the access level of administrator only. With the access level of operator, you can only
view b
ut cannot change the network settings.
Configuring the network settings
LOGO! 0BA8 provides a menu command for configuring network settings.
1. Switch LOGO! to programming mode.
2. Press
or to move the cursor to "①".
3. Press
OK
to confirm "①".
4. Press
or to move the cursor to "②".